Colorex

Betopaint

Helmatt, diffusion-open and highly covering waterborne paint for plastered surfaces.

  • Full matt
  • Vapour permeable
  • Opaque

Additional information

Product information
  • Product description
    Colorex Betopaint is a fully matte, water-based, highly diffusion-open paint for mineral substrates.
  • Area of application
    The paint is suitable for plastered facades, foundation walls, and outdoor plinths. The paint is also suitable for walls and ceilings indoors that are exposed to moisture, such as basement spaces. Betopaint is highly covering, which saves the number of paint layers, and very diffusion-open, which means that the paint, especially in systems with Betoprime, drives moisture out of the substrate. The diffusion openness, where the paint not only lets moisture through but also salts, means that the risk of flaking is minimized. On newly produced mineral surfaces, including prefab surfaces, the diffusion openness allows the natural lime deposition (carbonation) to pass through the paint film and sometimes appear as lime stains on the surface. A phenomenon that disappears after a couple of seasons. Betopaint is part of the Colorex Mix tinting system.
Technical information
  • Area of application

    Outdoor/Indoor

  • Binder

    Styrene acrylate

  • Colour

    White

  • Completely dry

    24 h

  • Density

    1.59 kg/l

  • Dust dry

    1 h

  • Flammability

    Not flammable

  • Gloss

    3 (full match)

  • Material consumption

    4–6 m²/L

  • Re-paintable

    2–4 h

  • Shelf life

    2 years unopened packaging. Store frost-free

  • Temperature at painting

    Minimum +5°C

  • Thinner/Cleaning

    Water

  • Tools for painting

    Brush, roller and paint sprayer

  • Vapor diffusion

    230 g/(m2·d) – Class V1, high, ISO 7783

  • Vapor diffusion (sd)

    0.09 meters

  • VOC category

    (Cat A/c): 40 g/l (2010)

  • Volume Solids

    42% %

  • Washability

    Class 1 (EN 13300)

  • Water permeability

    0.12 kg/(m²·h0.5) – Class W2, medium, SS EN 1062 3

  • Weight Solids

    63%

Application
  • Before painting

    Always start by reading through the instructions on the paint can and remember to be careful from the beginning. Good tools and careful preparation are prerequisites for a successful painting result. Stir the paint well from the bottom before you start painting. Room and surface temperature are also important for the final result. Do not paint if it is colder than +5°C. The substrate must be clean, dry, and firm, free from slag, salt deposits, and release agents. Brush or scrape away loose, old plaster and lime. Check by tapping the surface that previous treatment is well bonded to the substrate. Wash previously painted surfaces with paint cleaner and rinse with water. New mineral surfaces, such as plaster and concrete surfaces, are always primed with Betoprime. Remember to properly protect surrounding surfaces before you start painting.

  • Painting

    Paint 1–2 times with a roller, brush, or – after slight thinning – with a spray. Do not apply more coats than necessary for full coverage as this negatively affects the paint's diffusion openness. High solid content gives the paint good covering ability.

  • After painting

    Wipe the tools thoroughly before cleaning them in water. Seal the can tightly after use and keep out of reach of children. Liquid paint residues should not be poured into the drain but taken to the local recycling center.

Documents

We use AI to assist in the translation of product texts. Read more