Free Element

Water-based radiator paint on an alkyd resin base. The product does not yellow and has good drying ability and a very faint odor.

The product can be used on ferrous metals, e.g. steel, cast iron, etc., and various coatings (e.g. powder or plastic resin paints) after testing. The element spray is not suitable for direct painting on galvanized substrates.

All surfaces must be clean, dry, and free from rust and grease. Sand the surface first. Pre-treat rust-free and metal-clean areas with a suitable primer. Shake the can thoroughly for 1 minute from the moment the mixing balls start to hit. For technical reasons, the dip tube in an unused can contains a small amount of propellant. Therefore, spray quickly before the first use. Test spray. Coating may only be applied to cold elements or objects to be coated (at room temperature). NOTE! Surfaces and objects that are not to be coated must be carefully covered or taped.

2 sprays = approximately 40 µm dry film thickness. Flash-off time about 15 minutes at 20°C. Spray distance 15-25 cm.

After finishing the painting, the can should be turned upside down and the valve sprayed empty. Dispose of completely emptied spray cans as recyclable material.