Two-component water-dilutable epoxy paint. For painting concrete, wood fiber boards, etc. The paint is permeable to air humidity and therefore also suitable for ground floors. If there is a requirement for moisture permeability, a maximum of 2 coats is recommended.
:etag(760e5810d86600de25f3f4dd8999c217)/hagmans-nordic/pim-item/uploads/cesymbolMiljo/CE%20kopiera.jpg)
:etag(ca015d224c9f508101431aeb7a1d1d55)/hagmans-nordic/pim-item/uploads/m1symbolMiljo/pim-item/uploads/m1symbolMiljo/M1_eng.jpg)
During application and drying, the temperature of both the substrate and the ambient air must be between +12 °C and +30 °C. At the time of application, the paint itself should be at a temperature between +15 °C and +25 °C. Ensure good ventilation so that the water can evaporate before the paint cures. If the relative humidity exceeds 85%, there is a risk that the surface will become matte and patchy.
Epoxy
S3500-N
Allow approximately 3 hours of curing time before the next coat. However, do not wait longer than 12 hours. The freshly painted floor can be used after about 24 hours and reaches full wear resistance after 3-5 days.
A company 1,11, B company 1,29
Non-flammable
Approx. 80 blank
Approx. 0.12 kg/coating. 1 kg is enough for approx. 8 m²
1 hour
2 years. Store frost-free
Permeable to water in vapor form, ISO 7783
51%. 1 coating gives about 50 µm
Brushes, rollers, and other equipment are cleaned in water. Use protective gloves!
Mixing ratio:
Comp. A 1 part by weight
Comp. B 1 part by weight
Thinning: Approx. 10-20% water when priming on absorbent substrates.
New concrete floors must have cured for at least 1 week, be dry and free from dirt, oil, and similar substances. The cement film must be removed by, for example, diamond grinding, sandblasting, or acid washing. When repainting existing paint, the surface must be dull sanded and all loose paint removed.
New concrete floors must have cured for at least 1 week, be dry and free from dirt, oil, and similar substances. The cement film must be removed by, for example, diamond grinding, sandblasting, or acid washing. When repainting existing paint, the surface must be dull sanded and all loose paint removed.
With a brush or roller. Should be applied in two coats. Ensure good ventilation so that the water evaporates before the paint cures. At humidity above 85%, a matte and blotchy surface may occur. Small amounts, up to about 1 kg, can be mixed by hand with a rectangular stirring stick. Larger amounts should be mixed with an electric or pneumatic mixer, for example a low-speed drill with a suitable mixing paddle. Splash protection is recommended.
Sometimes certain rubber compounds in tires can cause plasticizer migration on waterborne paint or lacquer. On lighter colors, this can be perceived as yellowish marks.
We use AI to assist in the translation of product texts. Read more
