Hagmans - Klarlack EP-V - Hagmans Nordic

Article number	Size	SDS	SDS 2
39041	1 KG	SDS	SDS 2
39042	4 KG	SDS	SDS 2
39044	10 KG	SDS	SDS 2

Hagmans Klarlack EP-V is a two-component water-dispersed epoxy clear coat.

Additional information

Product information

Product description

High-gloss two-component waterborne epoxy clear lacquer. Intended for varnishing flake floors. Also used as a reinforcing lacquer on, for example, latex-painted wet room walls and the like.
Area of application

Hagmans Clear Varnish EP-V is used for varnishing flake floors, surface reinforcement on wet room walls made of latex, etc.

Technical information

Application temperature

During application and drying, the temperature of both the substrate and the ambient air must be between +12 °C and +30 °C. At the time of application, the paint itself should be at a temperature between +15 °C and +25 °C. Ensure good ventilation so that the water can evaporate before the paint cures. If the relative humidity exceeds 85%, there is a risk that the surface will become matte and patchy.
Colour

Transparent
Density

A: 1.05, B: 1.05kg/l
Drying time

Allow for approximately 10 hours of curing time before the next coat. However, do not wait longer than a maximum of 24 hours. The finished lacquered floor surface can be used after about 24 hours and reaches full wear resistance after 5-7 days.
Flammability

Non-flammable
Gloss

Approx. 90, high gloss
Material consumption

Approx. 0.12 kg/coating. 1 kg is enough for approx. 8 m²
Potlife

Max. 4 hours
Shelf life

2 years. Store frost-free.
Vapor diffusion (sd)

Permeable to water in vapor form.
Weight Solids

57% 1 coat gives 50-60 µm.

Application

Instructions for use

Mixing ratio:
Comp. A 1 part by weight
Comp. B 1 part by weight
Dilution: Can be diluted with water but is normally used without dilution.
Pretreatment

All dirt and all contaminants shall be removed.
Feel free to use a cleaning machine and scrubbing pad combined with a wet vacuum. Hagmans Golvrent facilitates the cleaning.
When recoating existing lacquer, the surface shall be sanded to a matte finish and all loose lacquer removed.
Application

With a brush or roller. Ensure good ventilation so that the water evaporates before the varnish has cured. At humidity over 85%, a matte and streaky surface can occur. It is important to apply the varnish evenly and thinly. If too much varnish is applied, there is a risk of water entrapment. Never apply more than a maximum of 125 g/m² = 8 m²/kg and avoid double coating wet on wet.

Small amounts, up to about 1 kg, can be mixed by hand with a rectangular stirring stick. Larger amounts should be mixed with an electric or pneumatic mixer, e.g., a low-speed drill with a suitable mixing paddle. Splash protection is recommended.

Brushes and other equipment are cleaned with water.

Use protective gloves!