Hagmans Latex Sealant is an elastic, acrylate-based sealant.

| Image | Article number | Size |
|---|---|---|
![]() |
1901364 | 300 ML |
Latexfog
Additional information
Product information
-
Product description
Hagmans Latex Sealant is a one-component, elastic, acrylate-based sealant that dries through the evaporation of water. -
Area of application
Hagmans Latex Sealant is used indoors for joints around windows and doors, wall and metal partitions, and ventilation or pipe penetrations, as well as for sealing gaps and cracks to prevent air leakage. The product can also be used for filling seams, sealing joints during the installation of gypsum boards, and repairing or sealing wooden facades—for instance, in connection with repainting. Latex Sealant is well-suited for bonding cellular plastic boards and similar materials, and it functions excellently as a water-based construction adhesive for most building materials. It can be applied to damp surfaces but should not be used in joints subject to constant water contact, such as in swimming pools or water reservoirs. If joint movement exceeds ±10% (tension/compression) of the joint width, highly elastic sealants are recommended. Hagmans Latex Sealant meets the requirements for CE marking in accordance with EN 15651-1, F INT."
Technical information
-
Application temperature
+5 °C to +30 °C
-
Completely dry
after 1–3 days, depending on dimensions, humidity, and temperature
-
Drying time
Dry to the touch: approx. 30 minutes
-
Re-paintable
with most types of paint. Due to the many different variants available on the market, it is recommended that a test be performed. This applies particularly when using paint with a gloss level of 2–3.
-
Shelf life
At least 24 months in unopened packaging at 0–25°C. Colorex Latex Sealant is freeze-thaw stable down to -18°C, for a maximum of three cycles.
Application
-
Pretreatment
The joint sides must be clean and free from oil, grease, and loose particles.
Degrease metal surfaces and sand away any loose paint. In cases where joint movement is expected, the depth at the center must not be less than 5 mm. Use a closed-cell backer rod that does not absorb water.
The backer rod should be 3–4 mm thicker than the width of the joint. Use a blunt tool to avoid damaging the rod. On highly absorbent substrates, the joint surfaces should be pre-coated with a primer
consisting of 1 part sealant mixed with 2 parts water. The primer should be allowed to dry for approximately 1 hour at +20°C. -
Application
Apply Hagmans Latex Sealant using a caulking gun or a pneumatic applicator. Press the sealant firmly against the substrate to ensure no air pockets form. Smooth out immediately after application using a suitable tool, such as a rubber or steel spatula, a damp sponge, or a brush. Protect the sealant from moisture for the first few days.
-
After painting
Clean the tools with water immediately after use. Remove stains and spills in the same way.
We use AI to assist in the translation of product texts. Read more





