Stålplast Spackel Carbon Fiber

Carbon Fibre is a carbon fiber-reinforced 2-component polyester putty, easy to apply and sand, completely pore-free. Can be used under powder coating.

Suitable applications include, among others, repairing sheet metal damage on cars, motorcycles, caravans, etc.

First stir the product in the jar.
Comp. A is mixed with 2–3% comp. B, e.g., on a mixing block or plate.
Do not overdose!
Do not mix more at a time than what is consumed within 4–5 minutes.

The filler should only be used on dry and well-cleaned surfaces. Sand the repair area so that rust and loose paint are removed. Oil and grease are removed with Hagmans Silicone Remover or thinner.

With a metal or rubber spatula.
Best working temperature 20°C. The working time is then about 5 min, and the curing time about 15 min. With forced drying at 40°C, the curing time is 10 minutes.
When drying with an IR lamp, the material can be sanded after 5 min. Use IR low intensity. The distance between the object and the IR lamp should be 50-70 cm. The object temperature must not exceed 70°C during drying.
Clean the working tools and any mixing plate after use with Hagmans Cellulose Thinner or thinner.

After approx. 15 min. at 20ºC, the putty can be sanded. Start with 120 grit and finish with 320-400 grit for best results.
Before spraying primer, filler, or surfacer, clean and degrease the substrate with a suitable degreasing agent.
Avoid letting filled surfaces come into direct contact with water (e.g., water-based degreasing agents).
Can be overpainted with all primers except water-dilutable products.