Hagmans - Filltec Softflex

Image	Article number	Size	SDS	SDS 2
	10962	2.16 KG	SDS	SDS 2

2K polyester putty developed for repairing small damages on plastic body parts. For professional use only.

Additional information

Product information

Product description

Paintable over most primer paints With the exception of water-thinned products.
Area of application

2K polyester filler developed to repair small damages on body parts made of plastic. For professional use only.

Technical information

Area of application

On plastics known within the automotive industry.
Base material

Unsaturated polyester
Cleaning

Hagmans Cellulose Thinner or thinner.
Colour

A-component is Gray/black, hardener red.
Density

1,69
Drying time

Sandy after 20-25 minutes at 20°C. Sandy after 10 minutes with forced drying at 40°C. Sandy after 5 minutes using IR low intensity. The distance between the object and the IR lamp should be 50-70 cm. The object temperature must not exceed 90°C during drying.
Emballage

Comp. A (putty) is delivered in a jar. Comp. B (hardener) is delivered in a tube.
Fire class

2b
Flash-point

31°C
Gelling time

Approx. 5 minutes with 2% hardener at +20°C
Härdartyp

50% benzoyl peroxide
Mixing ratio

Add 2-3% comp.B to comp.A and mix thoroughly
Operating temperature

+15 to +35
Re-paintable

With all non-water-dilutable primers for plastic.
Shelf life

18 months
VOC category

(Cat B/b) 250 g/l (2007).

Application

Health & safety

Use appropriate protective equipment
Filltec recommends that you use a fresh air mask.
Mixing ratio

Mixing ratio:
100 parts Filltec Softflex Part A,
2-3 parts Hardener
Pretreatment

Clean the surface before sanding.
Use warm soapy water, rinse with warm water.
Sand away any paint down to the metal surface with P180 – P240, or matte sand without going through any paint layer.
Before filling, clean and degrease the surface with a suitable degreasing agent.
Application

Apply the putty to bare plastic surface. Avoid thick putty edges around the damage; smooth the edges with the putty spatula. Do not apply Filltec Softflex directly to old sanded paint surfaces or on acid-containing Washprimer.
After treatment

By hand: P120 – P180 Use control color.
With machine: P240 – P320. P400 for final sanding in spot repair.
Check that there are no deep sanding scratches on the surface after sanding.
Before spraying primer, filler, or surfacer, clean and degrease the substrate with a suitable degreasing agent. Avoid direct contact of filled surfaces with water (e.g., water-based degreasers).