Mediumspackel LH

Wall putty LH is a waterborne all-purpose putty based on copolymer. Wall putty LH meets the requirements for M1 and CE marking according to EN 15824:2009 and EN 13963:2005. It also meets the requirements for the Nordic Swan Ecolabel.

The product is suitable for filling concrete, cement, gypsum boards, plaster, etc. It is particularly suitable for joint filling with a tape.

The substrate must be dry, clean, and well bonded. It is important that the surface temperature is not lower than +5°C!
The putty is applied with a steel spatula.
Drying time is affected by layer thickness, temperature, humidity, substrate, etc.
When sanding, safety goggles and respiratory protection should be used. The sanded surface must be dusted off before further treatment such as painting and wallpapering.
If the surface is to be wallpapered, it should be pre-pasted, following the wallpaper manufacturer's recommendations.
Tools are cleaned with water after use.

When sanding filler, eye protection and a face mask should be used.

The above provided data, as well as our instructions and recommendations, are based on experience and a number of trials. They are intended to help our customers find the most suitable working method and serve as guidance when choosing a product. Since the consumer's working conditions are beyond our control, we cannot assume any responsibility for the results obtained from the use of the product.