Asphalt-based cold-applied coating mass with reinforcing fibers. Used as a single coat to extend the durability of roofing felt.
| Image | Article number | Size | SDS |
|---|---|---|---|
|
15516601 | 6 KG | SDS |
Landora
Takmassa
Additional information
Product information
-
Product description
Bitumen-based, fiberglass-reinforced roof coating for the installation of seamless waterproofing layers. For the renovation of felt and metal roofs. -
Area of application
The product is mainly used for cardboard roofs.
Technical information
-
Colour
Black but becomes slate gray over time
-
Drying time
Drying time at 15°C: Walkable in about 1 month
-
Material consumption
Approx. 1 m²/kg
-
Tools for painting
Ceiling brush, paintbrush
Application
-
Instructions for use
The roof surface must be dry during the work. Rain immediately after the roof treatment has no effect on the tightness of the roof coating. Only minor changes in the surface layer may occur. The roof should not be walked on before the roof coating has stabilized. This takes about 2 months with full reinforcement.
-
Before painting
The substrate must be well cleaned and dry. Moss and algae must be removed. Paper blisters or the like should be adjusted so that the surface is as smooth as possible to achieve a good result. Remember to check and, if necessary, adjust the paper pockets that may occur in the upstand areas of the old roofing felt.
-
Painting
The roofing compound is usually spread with a roof brush in the direction of the roofing felt and towards the overlap so that the joint is filled. Applications should end with a straight edge about 5 cm up. Keep in mind that long brush strokes give a smoother surface. The recommended material quantity should be about 1 m²/kg, depending on surface texture and roofing felt quality.
-
After painting
STORE FROST-FREE
KEEP OUT OF REACH OF CHILDREN
We use AI to assist in the translation of product texts. Read more
